Right I have a problem.

I have put in a launch command for height and width then loaded up cs but nothing happened just a blank screen the problem persists. So I then uninstalled steam deleted everything and installed cs again now I still have the same problem. Now I goto config.cfg or userconfig.cfg does that have my launch commands that I have set previously or should it go back to default?

Now I think the only way of me seeing something on my screen when I load cs is for me to use the launch command for height and width am I correct?

Puts everything was as before, and puts only the necessary commands such as:"-noforcemparms -noforcemaccel"..etc...

It says

Input signal - out of range.

So I then right click on it goto properties and try everything there but still no luck :(
Should I just quit cs.

When I move my mouse about I have the sound in the backround

You may have to be the resolution you use normally (It is not that of CS), or frequency of the screen, or just get these commands and try to put the various resolutions of the CS ... :S

*You have to see the resolution you use normally

:S

If you put these commands and when the CS gives opens a kind of error, so that the screen can not support those values that put ... :S (My English is not perfect but I have that idea :D)

Fixed :D , I put my tv-out cable in then changed back to my normal screensize now I use my monitor again thanks for your help.

:D